Job Shop SIG Forum

Welcome to the Job Shop Group Forum. All Visitors may look at all topics and their associated threads on this Forum. However only AILU Members and Registered Users are allowed to create new topics or contribute to an existing topic. Thus to participate in this Forum, please remember to first log-in. If you are not a Registered User, please follow this link to register.

 

Topic: Job Shop forum / cutting mesh with 10mm holes on co2 laser

Page: 1

Posted: 23-04-2009 10:25 by Green Machines

i am looking for some info on this to see if it is able to be done on the laser  can anyone help on this topic i would be grateful for any info

 

thanks

paul

 
Posted: 23-04-2009 11:05 by WMD

Can be done no problem as long as the material is perfectly flat. Just switch of the height regulation. Beware if the material is bowed it will colide.
Posted: 23-04-2009 12:38 by Subcon Laser

Depending on the guage of the mesh. I would not expect a problem on 2mm or above.  on 1mm or below clamping the mesh may be of benefit. be aware of "warping" on fine mesh, or you may end up with a lot of scrap. 

Back to top